By Montalk <firstname.lastname@example.org>
Jamuary 2, 2003
This article describes a simple way to lessen intrusive EM
radiation in your home or apartment. A large source of dangerous EM radiation
comes in the form of microwaves emitted by cell phone towers. From personal
experimentation, and hearing the experiences of others, I am convinced that
some of these microwaves are being purposely beamed at us with the aim of
muddling our thoughts, altering our physical energy levels, reducing our
willpower, and maybe even subliminally implanting thoughts and coercive
emotional signatures in our minds. They may also be used for monitoring
Certain observations have been made about these signals:
1) they tend to be beamed through the window of a room where
one spends the most time, usually the window facing the
2) they are specifically directed to target and track a person
inside his home
3) the tracking speed is slow, and when the target moves,
the signal takes several seconds or minutes to search and find the target
at his new location.
4) when the target enters an area in his home that the signal
cannot reach, the signal goes on a wide search mode, thinking the target
has left his home and is traveling about town.
5) when the primary window is blocked off, the signal finds
another window or thin wall to penetrate
6) one can feel the effects of this signal, which may induce
a dull headache or pressure in the temples
I believe cell phone towers are used to generate these signals.
HAARP may play a part in this as well. A targeted person is tracked, either
via some signature characterized by the resonant characteristics of his
skull or DNA, or by tracking signals emitted by implants put into him during
abductions, or perhaps by more sophisticated methods. Computers perform
the calculations necessary to alter the signal of each of three cell phone
towers so as to triangulate a hotspot of signal at the target's location.
When the target moves, new calculations have to be made, which takes several
These signals consist of microwave carriers with ELF modulation
and audio encoded messages.
1) the microwaves resonate with DNA, can penetrate flesh and
bone, pass through some walls and windows, and are already in use by cell
2) these signals entrain brainwaves into a high-beta state,
which causes aggression and stress, or an alpha level that induces hypnotic
states and muddled thinking.
3) Besides the ELF waves that entrain one's brain, there are
also other signals consisting of audio messages. I have not verified what
these messages are, but they could be something along the lines of "You
are angry, You cannot think, You give up, You have no energy, etc..."
These audio messages could be modulated into the microwave carrier via frequency
modulation, while the ELF brain-entrainment signals could be amplitude modulated.
4) There may also be emotional signatures frequency-modulated
into the carrier. These can induce anger, frustration, sadness, or essentially
any human emotion into susceptible targets
Who is responsible for all this? Probably shadow factions
of the military/intelligence community associated with the One World Government.
They wish to keep the population docile, and keep all dissenters from acting
upon their dissenting thoughts. Maintaining order means that what is to
be controlled must be predictable, and so as long as people are docile,
they are predictable and hence controllable. This ensures the superiority
and stability of those in control.
There are two things you can do. First, you can learn to better
cope with these signals. The more you are in control of your own mind and
emotions, and the more observant you are about your own behavior, the less
influence these signals have upon your thoughts, feelings, and behavior.
Knowing is half the battle. Second, you can take additional steps to reduce
the level of EM radiation in your home, by blocking these signals.
Standard methods of blocking microwave mind programming signals
consist of Faraday cages and aluminum foil hats. But Faraday cages are difficult
and expensive to build. Aluminum foil hats actually increase one's signal
exposure unless they are grounded, and as long as one's skin does not touch
An easy, and relatively cost-effective, way to block microwaves
goes as follows:
1) Obtain these items:
*several emergency foil blankets, which come in small folded
packs, found in the camping section of department stores ($3 each)
*alligator clips, banana plugs, and speaker wire from Radio Shack
*duct tape or masking tape
* RF / MW signal detector, optional but recommended. They are expensive,
and the cheapest one that works well is the "Suresafe RF Signal Detector",
which costs $110.
* If you cannot afford a signal detector, take your best guess
at which windows or walls to cover. An ideal choice would be the corner
or wall closest to your bed. Any protection is better than no protection.
2) Use a soldering iron to make these:
* (4) 3 feet sections of speaker wire. One end with a banana
plug, other end with alligator clip
* (4) 4 feet sections of speaker wire. Both ends with alligator clips.
3) Use signal detector to record the relative signal strength
from all windows in the room you wish to protect, preferably the office
4) Without gaps, cover that entire wall with emergency foil
blankets, using masking or duct tape to hang up and connect the pieces.
It does not matter which side of the blankets faces the wall. If this is
too much, then just cover the window. If this is too ugly for you, then
you can make a safe room out of a large closet, or put your bed or desk
in the corner and cover the half of the walls adjacent to it.
4) Widen the banana plug, and stick into the ground jack on
your electrical outlet. This is the middle one that's round, not slotted.
Connect the alligator clip to the bottom edge of a blanket, so that it grips
onto both sides of the foil.
5) Use double-alligator wires to connect one blanket piece
6) Check for incoming radiation, add another blanket where
necessary. After an hour or two, check the other windows and compare their
signal strength to what you recorded previously. If they are now showing
intense incoming radiation, the signal has re-oriented and you must cover
that wall or window as well.
You will feel the difference. As an experiment, tape up only
half of a grounded blanket, so that you stand before an uncovered window.
Then tape up the rest so the window is covered. The pressure in your head
may disappear, only to reappear if you pull the blanket down again.
Microwaves cannot easily penetrate metal, especially grounded
metal such as the electrically grounded foil blankets. The reason why emergency
blankets are recommended over Reynolds aluminum foil is that these blankets
are larger, more durable, and easier to hang up. Though some signal still
gets through, and foil does not block pure ELF waves (ones without a higher
frequency carrier), this is one step to greatly reducing the level of incoming
OTHER MISCELLANEOUS TIPS:
* for temporary relief, go to the basement, lie on the floor,
or move around. These prevent strong hot spots from locking onto you. This
may seem paranoid, but test it with a signal detector and you will verify
this for yourself.
* use a negative ion generator (air ionizer) to improve the
quality of air in your home. Keep the generator away from computer equipment.
Negative ions improve your mood, and such generators also create EM noise
which interferes slightly with monitoring device. Negative ions and the
EM noise also counteracts negative astral and ethereal phenomena.
* avoid ingesting fluoride. Among other places, fluoride is
found in commercial soft drinks, bottled or canned ice tea, and tap water.
Fluoride impairs willpower and clarity of thought, which makes one more
susceptible to microwave mind programming signals.
* if one has a choice, avoid spring mattresses. Use instead
air mattresses, waterbeds, or futons. Platform beds made of wood are available
to support a futon mattress. Springs are like antennas, and focus EM and
ELF energy into your body while you sleep.
* get proper nutrition. This means enough calories, protein,
adequate minerals, plenty of clean water, and fresh fruits and vegetables.
Being deficient in any of these will cause mental weakness and submissiveness
to mind programming signals.
* be in the moment and observe yourself. Question baseless
thoughts or emotions you may have, especially negative emotions such as
aggression or depression that urge you to act without thinking. Becoming
aware of their presence is often enough to deactivate them.
* don't let the means become an ends. Reducing mind programming
signal influences should serve to increase your productivity and efficiency
in what you truly desire to do, the goals you choose to follow. Don't let
fear and paranoia usurp the importance of following your goals.
...send questions, comments, and follow-up reports to: email@example.com
All information posted on this web site is
the opinion of the author and is provided for educational purposes only.
It is not to be construed as medical advice. Only a licensed medical doctor
can legally offer medical advice in the United States. Consult the healer
of your choice for medical care and advice.