By Ken Adachi <Editor@educate-yourself.org>
http://educate-yourself.org/dc/silverterminatornotes.shtml
I
got tired of the skin reddening problem and the need to constantly move
around the penny Terminator
to another part of my body when using Don Croft's Terminator II with the copper
pennies. I found that covering the pennies with round discs of cotton pads
that were wetted with a 25% salt water solution would prevent the reddening
and skin irritation problem entirely, but I had to keep the cotton pads
moist in order for it to work properly. A slight inconvenience, as I had
to re-wet the pads about every 20 minutes. Attaching the silver discs allowed
me to zap for many hours without any itching or reddening, yet I didn't
have to worry about carrying around a bottle of saline solution and checking
the cotton pads.
Some people report a darkening of the skin under one of the
silver disc. The darkening is likely caused by silver atoms combining with
surface skin protein due to the unique composition of that person's sweat
and blood chemistry. It only affects the outer most layer of skin and will
fade in about two weeks. However, the body seems to acclimate to the silver
and the darkening usually reduces over time and will gradually drop to zero
with regular usage. If you are a person who gets the skin darkening reaction
and it bothers you, you can avoid it completely by using the cotton pads
wetted with 25% salt solution (as mentioned above) for the first few weeks
until your body acclimates. Also, remember that you can get 8 hours of zapping
time by wearing the Terminator on the sole of your foot or the palm of your hand (no other area of the body) while sleeping at night without
any worry of irritation, reddening, or skin darkening. You can make the
cotton pads out of heavy 100% cotton such as cotton flannel. Cut circular
discs about a 1/4" diameter larger than the pennies. I cut out a ring
using foam double stick tape to fit around the outside circumference of
the penny and stuck the cotton pads to that. It held very well and was not
affected by the dampness of the pads. Make up a 25% salt water solution
and place in a 2 oz. dropper bottle for application to the cotton pads if
you want to use this technique.
Clean the silver discs after each use with NON ABRASIVE metal
cleaner. I use one found at ACE Hardware called Flitz Metal Polish.
There are many others on the market. It only takes a minute or two to polish
the silver back to a nice shiny condition and you're ready for your next
zapping session.
Succor Punch
(SP) Jack If
you got a Mini Silver Terminator with the SP jack
installed, you need to use a 2.1mm plug if you make
up your own cable. I prefer to use a gold plated plug because you will never
have a poor contact problem as gold doesn't oxidize and gold is the second
best conductor of electricity after silver. Plug one end of your cable into
the SP jack and plug the other end into the SP crystal which has a 2.1mm
jack installed on it if you obtained the SP crystal from me. You can use
the Silver Terminator to pulse your SP crystal when not zapping or you can
zap and pulse the crystal at the same time. Doing both jobs at the same
time will drain more current out of the battery than just doing one job
at a time, so expect to change the battery more often if you plan on using
both simultaneously.
DC Jack If
you got the DC
Power Pak option with your Mini Silver Terminator, you can save on battery
drain by just plugging the supplied 9VDC transformer into the wall outlet
and plug the other end into the jack on the Terminator. If you got the coiled
car adapter from me, you can plug it into the cigarette lighter and into
the Terminator to power the unit from the car. This automatically disconnects
the 9 volt battery inside the Terminator from the circuit. The output 15
Hz voltage from the Terminator is about 1 volt higher (~6volts) using the
wall outlet than when using the battery to power the unit. This voltage
is so low, however, that you normally can't feel anything by touching the
discs with your fingers when the unit is turned on. This is perfectly desirable
as it doesn't take very much current to achieve the objective of GRADUALLY
knocking down the bug load in the body. When you kill off pathogens too
quickly, you have to contend with a big die-off and subsequent rapid waste
accumulation in the blood. This makes people feel ill, weak, headachy, etc.
It's better to kill off the bugs slow and steady and give your body the
time it needs to detox the waste by-products.
In addition to the problem of skin reddening and itching,
the copper penny plating will wear off pretty quickly if you're using a
regular Terminator and the zinc/aluminum alloy underneath will be exposed.
You don't really want that alloy against your skin. The silver discs used
for the Mini Silver Terminator are made from 30 gauge 99.9% pure silver plate.
Assuming you use NON ABRASIVE metal polish, there's enough silver there
to last for many years before wearing too thin.
Let me know of your experiences, good or bad, in using the
Silver Terminator as everyone is different and I'd like to find out what
sort of results you were able to obtain.
All information posted on this web site is
the opinion of the author and is provided for educational purposes only.
It is not to be construed as medical advice. Only a licensed medical doctor
can legally offer medical advice in the United States. Consult the healer
of your choice for medical care and advice.