From Ken Adachi
http://educate-yourself.org/products/sbbcoilsforchembusters.shtml
May 2009                                                                                                                                              6X Royal Cubit SBB coil for 5 gallon CB

SBB Coils for Chembusters from educate-yourself.org (May 2009)

The SBB coil for chembusters is made by taking a length of #14 copper wire cut to exactly the Royal Cubit l;ength of 524 mm (20.63 inches) multiplied five times (5X) = 2620 mm, or multiplied six times (6X) = 3144mm The coil is formed by bending the wire length exactly in half and then curling the wire into a flat coil starting from the bent end. This results in the two ends terminating on opposite sides of the coil.

The spiral shape causes the orgone energy to spiral into the center and causes the creative vortex action described by Viktor Schauberger and others. In the case of chembusters, the pipes are drawing the negative DOR orgone energy into the chembuster where it is being transmuted into the postive polarity of orgone and directed back into the atmosphere as OR orgone. The SBB coil, located near the bottom of the chembuster, helps to intensify and speed up the transmutation process.

I use a 5X SBB coil for the 2 gallon chembuster and a 6X SBB coil for the 5 gallon chembuster. To hold the spiral shape with evenly spaced turns I glue the coil to wax paper and then punch pin holes through the wax paper to allow the resin to permeate and fill the voids around the coil. I pour the first layer of renin about 1/4 inch thick, place the SBB in the center of the bucket (wax paper side up) and then add more resin and metal shavings on top of the SBB to the 3/4 inch level and allow this layer to harden for a day before adding the next layer. You can make an SBB coil from the information provided above or you can obtain a ready made coil from me.

1. 5X SBB coil for the 2 gallon chembuster = $25 + shipping

2. 6X SBB coil for the 5 gallon chembuster = $28 + shipping

To order:

Send me an e-mail at pitari (at) peoplepc.com (replace (at) with the symbol and no spaces) and tell me which SBB coil you want and your ZIP code (or country if outside the USA) and I'll tell you the shipping cost. Write "SBB coil" in the subject line.

Ken Adachi

---

© Copyright 2009 Educate-Yourself.org  All Rights Reserved.